It is vital to take time to understand the workings and installations of fishing equipment and techniques so that you can carry out fishing expeditions seamlessly. In the world of fishing, there are many things you need to be aware of. For now, however, we are going to talk about how to install a Garmin fish finder transducer to your boat. Here is what you need to know about.
Related article: Review of the Garmin Striker 4
The tools you need
You are going to need the following tools to install the Garmin fish finder transducer:
- Masking tape
- Drill and drill bits
- Marine sealant
- Two 13mm hex wenches
- A screwdriver
Following this, you need to assemble the transducer in place with the help of a transom mount bracket. Observe the transom turbulence. To do this, get an idea of what is happening at the back of the boat when it is underway. Know where you can see clear, turbulence-free water. This pays by offering you impeccable performance from your fish finder.
Know the hindrances that cause turbulence
Before installing the transducer, pay attention to steps and strakes. Refrain from mounting the transducer directly at the back of these. This is because it can lead to turbulence which can in turn cause problems in the depth sensor’s performance. If the boat is loaded onto a lift, understand where the bunks are as this can cause interference as well.
Related article: How to install a fish finder on the bow
Understand the mounting angle and mount the bracket
You always need to mount the transducer on the starboard side as it causes minimal turbulence. Pick a spot that is as far away from the lower unit as possible. Next, pay attention to the transom’s angle. Even the slightest kind of downward angle can lead to an improper nose-down angle causing turbulence and improper performance. Once you get this right, all you have to do is mount the bracket and the transducer.
After marking holes to the bottom of the bracket’s adjustment openings, begin the process of mounting the transducer. Run the cable and give then give it a try. Make adjustments to the transducer if required and you are all set to go fishing with complete gusto.
So there you go. Now that you know how to install a Garmin fish finder transducer, be sure to follow these instructions skillfully and in the best way possible. This ensures you have a speedy installation process with minimal obstacles and can ensure the optimal performance of your transducer.
Other fish finder articles:
- What is the best humminbird fish finder?
- The best shallow waters fish finder
- Fish finders for kayaks
- 10 best Garmin GPS devices
Updated: November 1, 2021
Leave a Comment